Multi-pixel Spectral Imaging Module

  • Home
  • News
  • Multi-pixel Spectral Imaging Module

Multi-pixel Spectral Imaging Module

PAM-256 multi-pixel energy spectrum imaging module is composed of one or several imaging unit. The CZT imaging unit is made of 16×16 pixel detector. With back-end ASIC, it can detect energy ranges from 10KeV~700KeV, fully satisfied γ camera and SPECT.

Multi-pixel Spectral Imaging Module

Direct splice: The module has a time sequence interface and a bias circuit. Added with FPGA, ADC and layout circuit, it will readout.
Indirect using: Systemize the module and design for special environment.
Splicing methods: USE TCP/IP or USB interface.

1. CZT Imaging Module Specification

(PAM200220-CZT)

CZT dimension 25.4×25.4×5 mm3
Pixel size 1.5×1.5 mm2
Pixel array 16×16
Energy resolution 90%pixels<6.5%@122KeV 25℃
Parameter configuration SPI interface
Signal readout All pixels can be read out at the same time
Interface Dasisy-chained connector
Detection range 20KeV~700MeV
Power 240mW/module
Module dimension 25.5×25.5×30 mm3
Defective pixel <6 pixels/module
Splicing 360° splicing with none-blind area

 

2. Multi-pixel Energy Spectrum Imaging Module Spectrum & Structure

 

 

 

 

 

 

 

 

powerwaywafer

For more information, please contact us email at victorchan@powerwaywafer.com and powerwaymaterial@gmail.com.

2019-04-24

Share this post

Related Posts

PbWO4 single crystal substrate

PAM XIAMEN offers PbWO4 single crystal substrate. PbWO4 single crystal substrate ,random orientation, 5 x 3 x 0.45mm,Single side polished PbWO4 single crystal substrate ,random orientation, 5 x 5 x 0.45mm,Single side polished PbWO4 (001) single crystal substrate 10x10x0.5mm,2sp PbWO4 single crystal substrate , [...]

2019-05-14meta-author
Photoluminescence-based material quality diagnostics in the manufacturing of CdZnTe ionizing radiation sensors

Photoluminescence-based material quality diagnostics in the manufacturing of CdZnTe ionizing radiation sensors A photoluminescence method was used for characterization of crystalline perfection of CdZnTe single crystals in the different stages of an up-to-date process of ionizing radiation sensor production. It was shown that the point [...]

2013-10-29meta-author , ,
Al2O3 (Sapphire)-5

PAM XIAMEN offers high-quality Al2O3 (Sapphire). Al2O3(10-14) Al2O3- Sapphire Wafer, (10-14), 10x10x0.5mm, 1 SP Fearures: Sapphire substrate is the popular substrates for III-V nitrides, superconductor and magnetic epi film due to less mis-matched lattice and stable chemical and physical properties. Wafer size: 10 [...]

2019-04-16meta-author
Charge Sensitive Pre-amplifier Chip

PAM-01C is a low noise and high gain charge sensitive preamplifier. It can be used as a key part for semiconductor detector, such as CZT and Si, and other detecting signal readout. 1. Charge Sensitive Pre-amplifier Chip Specifications Comparison Brands (PAM-01C) Gremat(PAM-110) Dimensions 24×15×3 mm3 22.7×21×3.4 mm3 Weight 5g 2.5g Power <0.3W 0.66W Powered by ±12V ±12V Operation temperature -20℃-+40℃ -20℃-+40℃ Equivalent noise level ENC:180e- ENC:260e- Falling [...]

2019-04-25meta-author
What Is PL (Photoluminescence)?

PAM-XIAMEN can supply semiconductor wafers, more wafer specifications please refer to https://www.powerwaywafer.com/products.html. If necessary, we will offer PL (photoluminescence) spectroscopy for the semiconductor wafers. 1. What is PL? About PL, it refers to the self-emission light produced by a material after being excited by light. When [...]

2022-08-09meta-author
100mm Silicon Carbide

There are more than 200 silicon carbide crystal types in the world, among which the mainstream crystal type of current silicon carbide wafer production is 4H-SiC. Below specification of 100mm silicon carbide in PAM-XIAMEN are available: 1. Specifications of 100mm Silicon Carbide 4H N-type Specificationsof Silicon Carbide N-type 100mm Diameter – polytype 4H-SiC A type N-type SiC substrate Resistance 0.015 [...]

2020-03-06meta-author