Q:Do you offer monocrystalline SiC or polycrystalline SiC?

A:We offer monocrystalline SiC currently.

2018-06-19

I am not sure whether practically LLO can be done on the PSS given it is not a flat surface

Q: I am not sure whether practically LLO can be done on the PSS given it is not a flat surface A: “laser lift-off” actually is according to “NL layer” as below image. If the NL layer is GaN layer, when it is heating to constant high [...]

2018-06-19meta-author

Q:What atomic ratio for Si/C in SiC ?

Q:What atomic ratio for Si/C in SiC ? A:Atomic ratio for Si/C in SiC is 1:1

2018-06-19meta-author

Q We actually want to check our reflectance (mirror type) measurement method on an LED structure on a PSS wafer. Would it be possible to get the same LED structure on both a PSS wafer and a single-side polished wafer so we can compare the two directly?

Q We actually want to check our reflectance (mirror type) measurement method on an LED structure on a PSS wafer. Would it be possible to get the same LED structure on both a PSS wafer and a single-side polished wafer so we can compare [...]

2018-06-19meta-author

One Side Polished Silicon Wafer

Q:We request for the following items 1. Silicon (Si) single crystal wafers, polished on one side N-type, orientation<100>, Resistivity 5E-3 ohm.cm, Thickness: 0.1 to 0.5 mm 2. Silicon (Si) single crystal wafers, polished on one side P-type, orientation <100>, Resistivity 5E-3 ohm.cm, Thickness: 0.1 to 0.5 [...]

Q:I was wondering if you carried any semi-insulating(not doped)SiC or single crystal HPSI SiC?

Q:I was wondering if you carried any semi-insulating(not doped)SiC or single crystal HPSI SiC? A: For our semi-insulating SiC substrate, it is V doped, we can not offer High Purity semi-insulating SiC, however we can offer undoped SiC if your quantity is good.

2018-06-19meta-author

Do these 2” PSS LED wafers have the same epi-stack as the 4” PSS? If not, please send me the diagram with thicknesses. Wavelength can be same: central 455nm

Q:Do these 2” PSS LED wafers have the same epi-stack as the 4” PSS? If not, please send me the diagram with thicknesses. Wavelength can be same: central 455nm A: the 2″ detail layer thickness and structure is same as 4″, no any difference. Wavelength:455nm+/-5nm [...]

2018-06-19meta-author

Read More

Float-Zone Mono-Crystalline Silicon

PAM-XIAMEN can offer float zone silicon wafer, which is obtained by Float Zone method. Monocrystalline silicon rods is got through float zone growth, and then process the monocrystalline silicon rods into silicon wafers, called float zone silicon wafers. Since the zone-melted silicon wafer is not in contact with the quartz crucible during the floating zone silicon process, the silicon material is in a suspended state. Thereby, it is less polluted during the process of floating zone melting of silicon. The carbon content and oxygen content are lower, the impurities are less, and the resistivity is higher. It is suitable for the manufacture of power devices and certain high-voltage electronic devices.
Read More

Test Wafer Monitor Wafer Dummy Wafer

As a dummy wafer manufacturer, PAM-XIAMEN offers silicone dummy wafer / test wafer / monitor wafer, which is used in a production device to improve safety in the beginning of production process and are used for delivery check and evaluation of process form. As dummy silicon wafers are often used for experiment and test, size and thickness thereof are important factors in most occasions. 100mm, 150mm, 200mm, or 300mm dummy wafer is available.
Read More

Nanofabrication Photoresist

PAM-XIAMEN Offers photoresist plate with photoresist
Read More

Photo Mask

PAM-XIAMEN Offers Photomasks

A photo mask is a thin coating of masking material supported by a thicker substrate, and the masking material absorbs light to varying degrees and can be patterned with a custom design. The pattern is used to modulate light and transfer the pattern through the process of photolithography which is the fundamental process used to build almost all of today’s digital devices.
Read More

CdZnTe (CZT) Wafer

Cadmium Zinc Telluride (CdZnTe or CZT) is a new semiconductor, which enables to convert radiation to electron effectively, it is mainly used in infrared thin-film epitaxy substrate, X-ray detectors and Gamma-ray CdZnTe detectors.
Read More

Ge(Germanium) Single Crystals and Wafers

PAM-XIAMEN offers 2”, 3”, 4” and 6” germanium wafer, which is short for Ge wafer grown by VGF / LEC. Lightly doped P and N type Germanium wafer can be also used for Hall effect experiment. At room temperature, crystalline germanium is brittle and has little plasticity. Germanium has semiconductor properties. High-purity germanium is doped with trivalent elements (such as indium, gallium, boron) to obtain P-type germanium semiconductors; and pentavalent elements (such as antimony, arsenic, and phosphorus) are doped to obtain N-type germanium semiconductors. Germanium has good semiconductor properties, such as high electron mobility and high hole mobility.

[email protected] [email protected]

Read More

Float-Zone Mono-Crystalline Silicon

PAM-XIAMEN can offer float zone silicon wafer, which is obtained by Float Zone method. Monocrystalline silicon rods is got through float zone growth, and then process the monocrystalline silicon rods into silicon wafers, called float zone silicon wafers. Since the zone-melted silicon wafer is not in contact with the quartz crucible during the floating zone silicon process, the silicon material is in a suspended state. Thereby, it is less polluted during the process of floating zone melting of silicon. The carbon content and oxygen content are lower, the impurities are less, and the resistivity is higher. It is suitable for the manufacture of power devices and certain high-voltage electronic devices.
Read More

Test Wafer Monitor Wafer Dummy Wafer

As a dummy wafer manufacturer, PAM-XIAMEN offers silicone dummy wafer / test wafer / monitor wafer, which is used in a production device to improve safety in the beginning of production process and are used for delivery check and evaluation of process form. As dummy silicon wafers are often used for experiment and test, size and thickness thereof are important factors in most occasions. 100mm, 150mm, 200mm, or 300mm dummy wafer is available.
Read More

Nanofabrication Photoresist

PAM-XIAMEN Offers photoresist plate with photoresist
Read More

Photo Mask

PAM-XIAMEN Offers Photomasks

A photo mask is a thin coating of masking material supported by a thicker substrate, and the masking material absorbs light to varying degrees and can be patterned with a custom design. The pattern is used to modulate light and transfer the pattern through the process of photolithography which is the fundamental process used to build almost all of today’s digital devices.
Read More

CdZnTe (CZT) Wafer

Cadmium Zinc Telluride (CdZnTe or CZT) is a new semiconductor, which enables to convert radiation to electron effectively, it is mainly used in infrared thin-film epitaxy substrate, X-ray detectors and Gamma-ray CdZnTe detectors.
Read More

Ge(Germanium) Single Crystals and Wafers

PAM-XIAMEN offers 2”, 3”, 4” and 6” germanium wafer, which is short for Ge wafer grown by VGF / LEC. Lightly doped P and N type Germanium wafer can be also used for Hall effect experiment. At room temperature, crystalline germanium is brittle and has little plasticity. Germanium has semiconductor properties. High-purity germanium is doped with trivalent elements (such as indium, gallium, boron) to obtain P-type germanium semiconductors; and pentavalent elements (such as antimony, arsenic, and phosphorus) are doped to obtain N-type germanium semiconductors. Germanium has good semiconductor properties, such as high electron mobility and high hole mobility.

Q:Do you offer monocrystalline SiC or polycrystalline SiC?

Q:Do you offer monocrystalline SiC or polycrystalline SiC?

Share this post

Related Posts

I am not sure whether practically LLO can be done on the PSS given it is not a flat surface

Q:What atomic ratio for Si/C in SiC ?

Q We actually want to check our reflectance (mirror type) measurement method on an LED structure on a PSS wafer. Would it be possible to get the same LED structure on both a PSS wafer and a single-side polished wafer so we can compare the two directly?

One Side Polished Silicon Wafer

Q:I was wondering if you carried any semi-insulating(not doped)SiC or single crystal HPSI SiC?

Do these 2” PSS LED wafers have the same epi-stack as the 4” PSS? If not, please send me the diagram with thicknesses. Wavelength can be same: central 455nm

Float-Zone Mono-Crystalline Silicon

Test Wafer Monitor Wafer Dummy Wafer

Nanofabrication Photoresist

Photo Mask

CdZnTe (CZT) Wafer

Ge(Germanium) Single Crystals and Wafers

Float-Zone Mono-Crystalline Silicon

Test Wafer Monitor Wafer Dummy Wafer

Nanofabrication Photoresist

Photo Mask

CdZnTe (CZT) Wafer

Ge(Germanium) Single Crystals and Wafers