Q:In your web site, the picture of the SiC wafer

Q:In your web site, the picture of the SiC wafer
does not look like regular, transparent-light green color SiC wafer.
Why is that?

A: Good question, the picture in website is Polarized light image.In regular, it is green color or grey color.

2018-06-19

Q: Regarding your red LED epiwafers, what about the top layer or cap layer on the epiwafer structure?

Q: Regarding your red LED epiwafers, what about the top layer or cap layer on the epiwafer structure? A: As before we have p+GaAs(several nanometers only) in the top layer, however these two years, due to technology innovation, and all foundry remove this layer [...]

2018-06-19meta-author

Q:Our application is for microwave annealing. Therefore, the silicon carbide must be able to absorb microwaves?

Q:Our application is for microwave annealing. Therefore, the silicon carbide must be able to absorb microwaves? A:Since the dielectric constant of 6H and 4H are large, so if SiC wafer is as absorbing materials, mainly to achieve through the structure design of Electromagnetic match.I don’t [...]

2018-06-19meta-author

Q:We are using 40×40 mil size and 45×45 mil size chips for 1W . And 45×22 or 38x22mil size for 0,5w . Eff. is min. 120lm/w , package form is 3535 ceramic no lens flat type, and 5050 smd flat type.Cct 6500k, cri min 70-75, drive current 350 mA ( it can be change if you have suggest for it ), can you give us suggestion?

Q:We are using 40×40 mil size and 45×45 mil size chips for 1W . And 45×22 or 38x22mil size for 0,5w . Eff. is min. 120lm/w , package form is 3535 ceramic no lens flat type, and 5050 smd flat type.Cct 6500k, cri min 70-75, [...]

2018-06-19meta-author

Q:What atomic ratio for Si/C in SiC ?

Q:What atomic ratio for Si/C in SiC ? A:Atomic ratio for Si/C in SiC is 1:1

2018-06-19meta-author

EPD for GaAs Substrate

PAM-XIAMEN can supply GaAs wafer with EPD less than 5000/cm2. Q: Could you please advise guaranteed EPD for below substrate and epi? Gallium Arsenide wafers, P/E 2″Ø×380±25µm, LEC SI undoped GaAs:-[100]±0.5°, n-type Ro=(0.8E8-0.9E8)Ohmcm, One-side-polished, back-side matte etched, 2 Flats, LT-GaAs EPI: 1-2µm, Resistivity >1E7 Ohm-cm, Carrier [...]

2018-09-06meta-author

Q:As to the wafer dicing – is it possible to get a non-rectangular dicing? such as 6mm x 8mm size?

Q:As to the wafer dicing – is it possible to get a non-rectangular dicing? such as 6mm x 8mm size? A:No problem, any size is workable.

2018-06-19meta-author

Read More

Float-Zone Mono-Crystalline Silicon

PAM-XIAMEN can offer float zone silicon wafer, which is obtained by Float Zone method. Monocrystalline silicon rods is got through float zone growth, and then process the monocrystalline silicon rods into silicon wafers, called float zone silicon wafers. Since the zone-melted silicon wafer is not in contact with the quartz crucible during the floating zone silicon process, the silicon material is in a suspended state. Thereby, it is less polluted during the process of floating zone melting of silicon. The carbon content and oxygen content are lower, the impurities are less, and the resistivity is higher. It is suitable for the manufacture of power devices and certain high-voltage electronic devices.
Read More

Test Wafer Monitor Wafer Dummy Wafer

As a dummy wafer manufacturer, PAM-XIAMEN offers silicone dummy wafer / test wafer / monitor wafer, which is used in a production device to improve safety in the beginning of production process and are used for delivery check and evaluation of process form. As dummy silicon wafers are often used for experiment and test, size and thickness thereof are important factors in most occasions. 100mm, 150mm, 200mm, or 300mm dummy wafer is available.
Read More

Nanofabrication Photoresist

PAM-XIAMEN Offers photoresist plate with photoresist
Read More

Photo Mask

PAM-XIAMEN Offers Photomasks

A photo mask is a thin coating of masking material supported by a thicker substrate, and the masking material absorbs light to varying degrees and can be patterned with a custom design. The pattern is used to modulate light and transfer the pattern through the process of photolithography which is the fundamental process used to build almost all of today’s digital devices.
Read More

CdZnTe (CZT) Wafer

Cadmium Zinc Telluride (CdZnTe or CZT) is a new semiconductor, which enables to convert radiation to electron effectively, it is mainly used in infrared thin-film epitaxy substrate, X-ray detectors and Gamma-ray CdZnTe detectors.
Read More

Ge(Germanium) Single Crystals and Wafers

PAM-XIAMEN offers 2”, 3”, 4” and 6” germanium wafer, which is short for Ge wafer grown by VGF / LEC. Lightly doped P and N type Germanium wafer can be also used for Hall effect experiment. At room temperature, crystalline germanium is brittle and has little plasticity. Germanium has semiconductor properties. High-purity germanium is doped with trivalent elements (such as indium, gallium, boron) to obtain P-type germanium semiconductors; and pentavalent elements (such as antimony, arsenic, and phosphorus) are doped to obtain N-type germanium semiconductors. Germanium has good semiconductor properties, such as high electron mobility and high hole mobility.

[email protected] [email protected]

Read More

Float-Zone Mono-Crystalline Silicon

PAM-XIAMEN can offer float zone silicon wafer, which is obtained by Float Zone method. Monocrystalline silicon rods is got through float zone growth, and then process the monocrystalline silicon rods into silicon wafers, called float zone silicon wafers. Since the zone-melted silicon wafer is not in contact with the quartz crucible during the floating zone silicon process, the silicon material is in a suspended state. Thereby, it is less polluted during the process of floating zone melting of silicon. The carbon content and oxygen content are lower, the impurities are less, and the resistivity is higher. It is suitable for the manufacture of power devices and certain high-voltage electronic devices.
Read More

Test Wafer Monitor Wafer Dummy Wafer

As a dummy wafer manufacturer, PAM-XIAMEN offers silicone dummy wafer / test wafer / monitor wafer, which is used in a production device to improve safety in the beginning of production process and are used for delivery check and evaluation of process form. As dummy silicon wafers are often used for experiment and test, size and thickness thereof are important factors in most occasions. 100mm, 150mm, 200mm, or 300mm dummy wafer is available.
Read More

Nanofabrication Photoresist

PAM-XIAMEN Offers photoresist plate with photoresist
Read More

Photo Mask

PAM-XIAMEN Offers Photomasks

A photo mask is a thin coating of masking material supported by a thicker substrate, and the masking material absorbs light to varying degrees and can be patterned with a custom design. The pattern is used to modulate light and transfer the pattern through the process of photolithography which is the fundamental process used to build almost all of today’s digital devices.
Read More

CdZnTe (CZT) Wafer

Cadmium Zinc Telluride (CdZnTe or CZT) is a new semiconductor, which enables to convert radiation to electron effectively, it is mainly used in infrared thin-film epitaxy substrate, X-ray detectors and Gamma-ray CdZnTe detectors.
Read More

Ge(Germanium) Single Crystals and Wafers

PAM-XIAMEN offers 2”, 3”, 4” and 6” germanium wafer, which is short for Ge wafer grown by VGF / LEC. Lightly doped P and N type Germanium wafer can be also used for Hall effect experiment. At room temperature, crystalline germanium is brittle and has little plasticity. Germanium has semiconductor properties. High-purity germanium is doped with trivalent elements (such as indium, gallium, boron) to obtain P-type germanium semiconductors; and pentavalent elements (such as antimony, arsenic, and phosphorus) are doped to obtain N-type germanium semiconductors. Germanium has good semiconductor properties, such as high electron mobility and high hole mobility.

Q:In your web site, the picture of the SiC wafer

Q:In your web site, the picture of the SiC wafer

Share this post

Related Posts

Q: Regarding your red LED epiwafers, what about the top layer or cap layer on the epiwafer structure?

Q:Our application is for microwave annealing. Therefore, the silicon carbide must be able to absorb microwaves?

Q:What atomic ratio for Si/C in SiC ?

EPD for GaAs Substrate

Q:As to the wafer dicing – is it possible to get a non-rectangular dicing? such as 6mm x 8mm size?

Float-Zone Mono-Crystalline Silicon

Test Wafer Monitor Wafer Dummy Wafer

Nanofabrication Photoresist

Photo Mask

CdZnTe (CZT) Wafer

Ge(Germanium) Single Crystals and Wafers

Float-Zone Mono-Crystalline Silicon

Test Wafer Monitor Wafer Dummy Wafer

Nanofabrication Photoresist

Photo Mask

CdZnTe (CZT) Wafer

Ge(Germanium) Single Crystals and Wafers