Q:We want to know the refractive index of these SiC wafers?

A:The refractive index is no=2.707, ne=2.755

2018-06-19

Q: For GaN on sapphire, could you please let us know which side is epi-ready?

Q: For GaN on sapphire, could you please let us know which side is epi-ready? A: Ga-face,epi-ready and N face is connecting to sapphire.

2018-06-19meta-author

Q:For Si-doped GaN, what are the resistivity and mobility?

Q:For Si-doped GaN, what are the resistivity and mobility? A:Mobility:150-200Resistivity<0.05ohm.cm,

2018-06-19meta-author

Q:Do you have the optical characterization data for this InGaN wafer? We want to know want wavelength it emits when excited optically. A PL spectrum would be perfect. Also, is the InGaN grown on any buffer layer? What is the uniformity of the Indium composition? Any In segregation or clusters?

Q:Do you have the optical characterization data for this InGaN wafer? We want to know want wavelength it emits when excited optically. A PL spectrum would be perfect. Also, is the InGaN grown on any buffer layer? What is the uniformity of the Indium [...]

2018-06-19meta-author

Q: Regarding your red LED epiwafers, what about the top layer or cap layer on the epiwafer structure?

Q: Regarding your red LED epiwafers, what about the top layer or cap layer on the epiwafer structure? A: As before we have p+GaAs(several nanometers only) in the top layer, however these two years, due to technology innovation, and all foundry remove this layer [...]

2018-06-19meta-author

Q: Can you offer some SiC(0001) wafers with low but intentionnal misorientation in the 1° to 2° range?

Q: Can you offer some SiC(0001) wafers with low but intentionnal misorientation in the 1° to 2° range? A: We can offer misorientation in low degree, no problem.

2018-06-19meta-author

Do these 2” PSS LED wafers have the same epi-stack as the 4” PSS? If not, please send me the diagram with thicknesses. Wavelength can be same: central 455nm

Q:Do these 2” PSS LED wafers have the same epi-stack as the 4” PSS? If not, please send me the diagram with thicknesses. Wavelength can be same: central 455nm A: the 2″ detail layer thickness and structure is same as 4″, no any difference. Wavelength:455nm+/-5nm [...]

2018-06-19meta-author

Read More

Float-Zone Mono-Crystalline Silicon

PAM-XIAMEN can offer float zone silicon wafer, which is obtained by Float Zone method. Monocrystalline silicon rods is got through float zone growth, and then process the monocrystalline silicon rods into silicon wafers, called float zone silicon wafers. Since the zone-melted silicon wafer is not in contact with the quartz crucible during the floating zone silicon process, the silicon material is in a suspended state. Thereby, it is less polluted during the process of floating zone melting of silicon. The carbon content and oxygen content are lower, the impurities are less, and the resistivity is higher. It is suitable for the manufacture of power devices and certain high-voltage electronic devices.
Read More

Test Wafer Monitor Wafer Dummy Wafer

As a dummy wafer manufacturer, PAM-XIAMEN offers silicone dummy wafer / test wafer / monitor wafer, which is used in a production device to improve safety in the beginning of production process and are used for delivery check and evaluation of process form. As dummy silicon wafers are often used for experiment and test, size and thickness thereof are important factors in most occasions. 100mm, 150mm, 200mm, or 300mm dummy wafer is available.
Read More

Nanofabrication Photoresist

PAM-XIAMEN Offers photoresist plate with photoresist
Read More

Photo Mask

PAM-XIAMEN Offers Photomasks

A photo mask is a thin coating of masking material supported by a thicker substrate, and the masking material absorbs light to varying degrees and can be patterned with a custom design. The pattern is used to modulate light and transfer the pattern through the process of photolithography which is the fundamental process used to build almost all of today’s digital devices.
Read More

CdZnTe (CZT) Wafer

Cadmium Zinc Telluride (CdZnTe or CZT) is a new semiconductor, which enables to convert radiation to electron effectively, it is mainly used in infrared thin-film epitaxy substrate, X-ray detectors and Gamma-ray CdZnTe detectors.
Read More

Ge(Germanium) Single Crystals and Wafers

PAM-XIAMEN offers 2”, 3”, 4” and 6” germanium wafer, which is short for Ge wafer grown by VGF / LEC. Lightly doped P and N type Germanium wafer can be also used for Hall effect experiment. At room temperature, crystalline germanium is brittle and has little plasticity. Germanium has semiconductor properties. High-purity germanium is doped with trivalent elements (such as indium, gallium, boron) to obtain P-type germanium semiconductors; and pentavalent elements (such as antimony, arsenic, and phosphorus) are doped to obtain N-type germanium semiconductors. Germanium has good semiconductor properties, such as high electron mobility and high hole mobility.

[email protected] [email protected]

Read More

Float-Zone Mono-Crystalline Silicon

PAM-XIAMEN can offer float zone silicon wafer, which is obtained by Float Zone method. Monocrystalline silicon rods is got through float zone growth, and then process the monocrystalline silicon rods into silicon wafers, called float zone silicon wafers. Since the zone-melted silicon wafer is not in contact with the quartz crucible during the floating zone silicon process, the silicon material is in a suspended state. Thereby, it is less polluted during the process of floating zone melting of silicon. The carbon content and oxygen content are lower, the impurities are less, and the resistivity is higher. It is suitable for the manufacture of power devices and certain high-voltage electronic devices.
Read More

Test Wafer Monitor Wafer Dummy Wafer

As a dummy wafer manufacturer, PAM-XIAMEN offers silicone dummy wafer / test wafer / monitor wafer, which is used in a production device to improve safety in the beginning of production process and are used for delivery check and evaluation of process form. As dummy silicon wafers are often used for experiment and test, size and thickness thereof are important factors in most occasions. 100mm, 150mm, 200mm, or 300mm dummy wafer is available.
Read More

Nanofabrication Photoresist

PAM-XIAMEN Offers photoresist plate with photoresist
Read More

Photo Mask

PAM-XIAMEN Offers Photomasks

A photo mask is a thin coating of masking material supported by a thicker substrate, and the masking material absorbs light to varying degrees and can be patterned with a custom design. The pattern is used to modulate light and transfer the pattern through the process of photolithography which is the fundamental process used to build almost all of today’s digital devices.
Read More

CdZnTe (CZT) Wafer

Cadmium Zinc Telluride (CdZnTe or CZT) is a new semiconductor, which enables to convert radiation to electron effectively, it is mainly used in infrared thin-film epitaxy substrate, X-ray detectors and Gamma-ray CdZnTe detectors.
Read More

Ge(Germanium) Single Crystals and Wafers

PAM-XIAMEN offers 2”, 3”, 4” and 6” germanium wafer, which is short for Ge wafer grown by VGF / LEC. Lightly doped P and N type Germanium wafer can be also used for Hall effect experiment. At room temperature, crystalline germanium is brittle and has little plasticity. Germanium has semiconductor properties. High-purity germanium is doped with trivalent elements (such as indium, gallium, boron) to obtain P-type germanium semiconductors; and pentavalent elements (such as antimony, arsenic, and phosphorus) are doped to obtain N-type germanium semiconductors. Germanium has good semiconductor properties, such as high electron mobility and high hole mobility.

Q:We want to know the refractive index of these SiC wafers?

Q:We want to know the refractive index of these SiC wafers?

Share this post

Related Posts

Q: For GaN on sapphire, could you please let us know which side is epi-ready?

Q:For Si-doped GaN, what are the resistivity and mobility?

Q:Do you have the optical characterization data for this InGaN wafer? We want to know want wavelength it emits when excited optically. A PL spectrum would be perfect. Also, is the InGaN grown on any buffer layer? What is the uniformity of the Indium composition? Any In segregation or clusters?

Q: Regarding your red LED epiwafers, what about the top layer or cap layer on the epiwafer structure?

Q: Can you offer some SiC(0001) wafers with low but intentionnal misorientation in the 1° to 2° range?

Do these 2” PSS LED wafers have the same epi-stack as the 4” PSS? If not, please send me the diagram with thicknesses. Wavelength can be same: central 455nm

Float-Zone Mono-Crystalline Silicon

Test Wafer Monitor Wafer Dummy Wafer

Nanofabrication Photoresist

Photo Mask

CdZnTe (CZT) Wafer

Ge(Germanium) Single Crystals and Wafers

Float-Zone Mono-Crystalline Silicon

Test Wafer Monitor Wafer Dummy Wafer

Nanofabrication Photoresist

Photo Mask

CdZnTe (CZT) Wafer

Ge(Germanium) Single Crystals and Wafers