2-7.Primary Flat Orientation
The at of the longest length on the wafer, oriented such that the chord is parallel with a specied low index crystal plane. Measured on one wafer per ingot using Laue back-reection technique with manual angle measurement.
2018-06-28meta-author
3-9. Comet Tails
Comet tails have a discrete head and trailing tail. These features are aligned parallel to the major at. Usually, all comet tails tend to be of the same length. Count once per occurrence. Two comet tails within 200 microns count as [...]
2018-06-28meta-author
5-4-4-1 SiC Epitaxial Growth Processes
An interesting variety of SiC epitaxial growth methodologies, ranging from liquid-phase epitaxy, molecular beam epitaxy, and chemical vapor deposition(CVD) have been investigated . The CVD growth technique is generally accepted as the most promising method for attaining epilayer reproducibility, quality, [...]
2018-06-28meta-author
2-16.Pits
Individual distinguishable surface anomalies, which appears as a depression in the wafer surface with a lengthto-width ratio less than 5 to 1, and visible under high intensity illumination.
2018-06-28meta-author
5-4 SiC Semiconductor Crystal Growth
As of this writing, much of the outstanding theoretical promise of SiC electronics highlighted in the
previous section has largely gone unrealized. A brief historical examination quickly shows that serious
shortcomings in SiC semiconductor material manufacturability and quality have greatly hindered the
development [...]
2018-06-28meta-author
3-2. Scratches
Grooves or cuts below the surface plane of the wafer having a length-to-width ratio of greater than 5 to 1. Scratches are speci ed by the number of discrete scratches times the total length in fractional diameter.
2018-06-28meta-author