AlGaInP is used in manufacture of light-emitting diodes of high-brightness red, orange, green, and yellow color, to form the heterostructure emitting light. It is also used to make diode lasers.
AlGaInP layer is often grown by heteroepitaxy on gallium arsenide or gallium phosphide in order to form a quantum well structure.
1.Specs of AlGaInP Wafers on Chips
AlGaInP LED Wafer [...]
PAM-XIAMEN offers high-quality AlN on silicon and sapphire wafer, which is AlN epitaxial thin film grown on single crystal sapphire/Si substrate, that way can provide the most cost-effective solution to grow high quality III-V nitride thin film.
1. Wafer List:
Undoped AlN Template on Sapphire, [...]
2019-04-16meta-author
PAM XIAMEN offers YSZ ( Yittrium stablized ZrO2).
3.5 mol.% YSZ Ceramic Substrate 10x10x0.5 mm , fine ground on both sides
3.5% YSZ Ceramic Substrate 10x10x0.5 mm, two sides polished
3.5mol.% YSZ Ceramic Substrate 10x10x0.5 mm , one side polished
8% YSZ Ceramic Substrate [...]
2019-04-18meta-author
PAM-XIAMEN offers 10*10mm2 SI (Semi-insulating) Freestanding GaN Substrate, which has a resistivity greater than 106 ohm-cm. Semi-insulating gallium nitride substrate with the advantages high critical breakdown electric field and good thermal stability are widely used in high-frequency and high-power devices. Following listed is one of the specifications:
1. [...]
2020-08-17meta-author
PAM-XIAMEN, one of LED wafer manufacturers, offers GaN Wafer for Fabricating LED Devices, which is GaN Epi Structure with InGaN MQWs on sapphire substrate, and can be blue or green emission:
1. Specification of GaN Wafer for LED Devices
No1. PAM200614-GAN-LED
size : 2 inch
WD : 455 ± 10nm
[...]
2020-06-02meta-author
PAM-XIAMEN can provide etching silicon wafer in P type and N type, more specifications please see: https://www.powerwaywafer.com/silicon-wafer/etching-wafer.html. The etching of silicon wafers is divided into isotropy and anisotropy, shown as Fig. 1. Isotropy etching means that the etching rate of silicon in all directions is the same during the etching process, [...]
2022-07-01meta-author